Sauder Cannery Bridge Serie Instrucciones De Montaje página 36

Step 30
å
Fasten the CUP HINGES (11) to the PENCIL DRAWER FRONT (L).
Use four 1/2" FLAT HEAD SCREWS (22).
å
NOTE: You should start each SCREW a few turns before completely
tightening any of them.
å
Fasten the CUP HINGES (11) to the PENCIL DRAWER BOTTOM (M).
Use four SILVER 1/2" PAN HEAD SCREWS (23).
å
NOTE: You should start each SCREW a few turns before completely
tightening any of them.
Page 36
22
1/2" FLAT HEAD SCREW
(4 used in this step)
M
L
www.sauder.com/service
23
SILVER 1/2" PAN HEAD SCREW
(4 used in this step)
11
431315