Sauder Portage Park Serie Instrucciones De Montaje página 8

Step 3
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (1) to the ENDS (C and D). Use twelve 1/2"
å
FLAT HEAD SCREWS (21).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
å
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to fi nd the other hole that lines up with the hole in the ENDS.
Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push the black lever up and pull the SLIDE from the RAIL.
1/2" FLAT HEAD SCREW
(12 used in this step)
Open end
Page 8
Use these holes.
1
21
1
1
C
www.sauder.com/service
2
1
D
7
Open end
1
426275