Sauder OFFICE WORKS AFFIRM Serie Instrucciones De Montaje página 18

Step 12
1
BLACK 9/16" LARGE HEAD SCREW
77G
G
å
Fasten the Z-LOCK BRACKET (77G) to one of the
DRAWER FRONTS (G). Use two BLACK 9/16" LARGE
HEAD SCREWS (1S).
3
U n fi
n i s h
s u r
f a c
D579
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D716) into the grooves
in the DRAWER SIDES (D579 and D580) and
DRAWER FRONT (G).
Page 18
(2 used in this step)
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the groove.
e d
e
D716
D580
G
2
1S
D579
Groove
å
Insert the DRAWER SIDES (D579 and D580) at an angle
into the slot at each end of the DRAWER FRONT (G).
4
D109
D579
D716
å
Fasten the DRAWER BACK (D109) to the DRAWER
SIDES (D579 and D580). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D716) inserts
into the groove of the DRAWER BACK (D109).
å
Repeat this step for the remaining small DRAWER.
427873
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D580
G
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
Be sure the
DRAWER
BOTTOM
D580
inserts into
the DRAWER
BACK groove.
www.sauder.com/commercial-office/service
9