Sauder OFFICE WORKS AFFIRM Serie Instrucciones De Montaje página 20

Step 14
1
D581
Groove
å
Insert the LARGE DRAWER SIDES (D581 and D582)
at an angle into the slot at each end of the LOCKING
DRAWER FRONT (H).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the LARGE DRAWER BACK (D78) to the LARGE DRAWER SIDES (D581 and D582). Use four
BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D707) inserts into the groove of the DRAWER BACK (D78).
Page 20
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D582
H
D78
D581
D707
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the LARGE DRAWER BOTTOM (D707) into the
grooves in the LARGE DRAWER SIDES (D581 and D582)
and LOCKING DRAWER FRONT (H).
D582
427873
U n fi
n i s h
s u r
e d
f a c
e
D707
D581
D582
H
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/commercial-office/service
9
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the groove.