Rohde KE Serie Manual De Instrucciones página 37

4.6. Connect to the power supply & connect the controller
4.6.1. Power supply
The kiln is equipped with a mains supply cable. The power supply data can be seen on the type plate. The power
supply must be suitable for the requirements of the kiln. The plug must be located next to the kiln.
Please note:
Do not use extension cables! The mains supply cable must not come into contact with the hot kiln!
Note:
Regional voltage fluctuations are possible and will lead to fluctuations in the nominal output. In Germany, for
instance, the nominal voltage of 230 / 400 is subject to voltage fluctuations of 10%. If the voltage drops from 230 to
210 under load, the output of the kiln will be reduced by 16%.
4.6.2. Connection of the controller
Step Action required
The controller is connected to the kiln with a 14-pin plug-and-screw
1
connection.
⇒ You will find the black socket next to the electric connection on
the side of the switch cabinet.
⇒ First plug in the black plug of the controller.
2
⇒ You might need to turn it a little until it locks into position. Then
turn the screw connection ring, in order to protect the
connection.
4.7. Mount the controller
4.7.1. Mounting the controller on the kiln
Step Action required
Place the panel for mounting the controller in a position that will
1 allow the star-shaped knob to be turned until it locks into the
position indicated
When the panel is fixed, you can start mounting the controller on the
2
panel.
You will find a detailed explanation in your user's manual for the
3
controller.
35 / 166 - EN -
Illustration
Illustration