turbionaire TREND PLUS Manual De Instrucciones página 14

BOOST MODE
1. Briefly press BOOST key to increase fan speed to 7 for 5 minutes (standard configuration) after which BOOST mode is deactivated.
2. Any pressing of any button except the ON/OFF buttons, Ambient LED lighting (for models equipped with this function) and DIMMER,
cancels BOOST mode.
3. LED indicator: YELLOW flashing
AMBIENT LIGHT ON/OFF
Briefly press the "Ambient light" button, then the LED is on/off (only for models equipped with this function).
DIMMER
When it is pressed successively, the intensity of the LED indicator positioned on the side of the device will increase: after reaching the
maximum, the intensity restarts from the minimum (off) and increases again: after a short period of time in which DIMMER button was not
pressed, the intensity is considered set.
RESTORE TO FACTORY SETTINGS
Press the "RESET" button on the device for at least 5 seconds, when the LED flashes BLUE, release the button, then press it again the "RESET"
button until the LED indicator turns RED, and the setting from the factory is restored.
D.2. SPECIFIC FUNCTIONS
SETTING TIME FOR TIMER MODE
1. Press the Timer key and hold for at least 5 seconds, when the LED indicator flashes GREEN, press the keys
to adjust the timer (setting intervals: 1, 3, 5, 10, 20, 30 minutes);
2. LED indicator: Flashing PURPLE with each press, minutes 1 and 30 are highlighted by flashing BLUE).
14