turbionaire TREND PLUS Manual De Instrucciones página 7

2. INSTALLATION
Attention: Make sure that the device is turned off using the main switch. Install the device near a
wall plug. The device must be installed by a qualified electrician.
A. WALL INSTALLATION
1. Make sure that you have chosen the correct supply voltage, according to the label, before
connecting the device to the power source.
2. Drill an appropriate hole in the wall and make sure that there are no cables or pipes inside
the wall when you perform this operation. The hole in the wall must have a slight
inclination towards the outside to allow the condensation to drain.
103 mm
1
7