Hilti SID 2-A Manual De Instrucciones Original página 28

2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
5.4 Switching on
▶ Press the control switch.
➥ Speed of rotation is regulated by the distance the control switch is
pressed in.
5.5 Switching off
▶ Release the control switch.
5.6 Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the
middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
5.7 Fitting an accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the tool.
2. Pull the chuck ring forward and hold it in this position.
3. Push the accessory tool into the chuck as far as it will go (until it engages).
5.8 Removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when using the power tool and when changing
accessory tools.
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the chuck ring forward and hold it in this position.
3. Pull the accessory tool out of the chuck.
4. Release the chuck ring.
5.9 Fitting the belt hook (optional)
WARNING
Risk of injury! Hazard presented by a falling power tool.
▶ A falling power tool may present a risk of injury to yourself and others.
Check that the belt hook is fitted securely before beginning work.
24 English
Printed: 10.07.2019 | Doc-Nr: PUB / 5206085 / 000 / 04
2
3
4
5
2081236
*2081236*