Publicidad
Idiomas disponibles
Idiomas disponibles
16
iNSTALLATiON iNSTruCTiONS
4. With the door on a protected surface, remove all
screws on each side of the door and lift off the inner
door frame using a flat blade screwdriver.
Remove the latch hook and blank and install them on
the opposite side.
Inner door
frame
Blank
5. Remove the 4 screws securing the hinges to the door
frame. Remove the two plastic cover caps. Reinstall
the hinges and cover caps on the opposite sides from
which they were removed.
6. With the hinges and cover caps in the new locations,
remount the inner door frame onto the outer door
frame with the screws removed in step 4 above.
WArNiNg
w
Be sure to support the weight of the door before
installing the hinge screws.
Latch hook
Hinge
assembly
Cover cap
7. Reinstall the door.
While supporting the door, install the four hinge
screws removed in step 2. Test the swing of the
door to make sure the hinges and latch are properly
aligned and that the door opens, closes and latches
properly in both directions.
Swing
Door
Easy load door (on some models)
WArNiNg
w
Be sure to support the weight of the door before
installing the hinge screws.
ON THE CABINET :
1. Open the door from the side so that the hinge
screws are accessible.
2. Remove the four hinge screws
While supporting the door, remove the four hinge
screws, two from each hinge. Set the door aside face
down on a protected surface to prevent damage to
the door or the work surface.
Two large
screws
Two small
screws
Publicidad
