Start-Up Operation - Soehnle GJA24-500 Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
A. Start-up Operation
Fill the device only while the
power supply unit is disconnec-
ted!
1. Remove the upper part.
2. Fill with distilled water up to
the maximum water level indi-
cator (100 ml).
3. Add 1 to 2 drops SOEHNLE
fragrance oil. Reattach upper
part correctly.
4. Connect power supply unit.
5. Place on a level surface.
6. Switch on.
B. Cleaning
For reasons of hygiene the device
must be cleaned after each
D. Troubleshooting
Symptom
Error
No
Power supply unit not properly
mist
connected
Not enough water in the water
tank
Too much water in the water tank
The upper part is plugged up by a
water film or something else
filling - at least every three
days. Before cleaning, dis -
connect the unit from the mains.
1. Remove remaining water.
Do not use ventilation ope-
ning!
2. Use cloth and cotton swabs to
wipe out water tank.
Do not use strong or abrasive
cleaning agents.
C. Specifications
Dimensions: Ø 107 x 212 mm
Rated voltage: 24V≈
Nominal output: 10 W
Water volume: 100ml
Power supply unit:
Modell: GJA24-500
Primary: 230V / 50Hz
Secondary: 24V≈500mA
ta=40°C
Solution
Insert power supply unit into
power outlet and device
Fill up to the maximum
water level indicator
Pour out water until it
reaches the maximum water
level indicator
Use cloth to clean
EN
5

Publicidad

Tabla de contenido
loading

Tabla de contenido