Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL WARNING
It must be possible to disconnect the appliance
from the power supply by unplugging it if plug
is accessible, or by a multi-pole switch
installed upstream of the socket in accordance
with the wiring rules and the appliance must be
earthed in conformity with national electrical
safety standards.
• When the appliance is installed, the mains
socket must be within easy reach.
• When heating, the maximum current of the
appliance is 10A, so please make sure that
the power supply system (voltage, current
and the cable) is applicable to the load of
the applied appliance.
• In order to ensure your safety, you must
plug the cable into a socket which
connected to earth. And please check your
socket to make sure that it is connected
with reliable earth correctly.
• Do not use extension leads, multiple
sockets or adapters.
• The electrical components must not be
accessible to the user after installation.
• Do not operate the appliance when you are
wet or barefoot.
• Do not operate the appliance if it has a
damaged power cable or plug, if it is not
working properly, or if it has been damaged
or dropped.
• If the supply cord is damaged, it must be
replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard
– risk of electric shock.
• Disconnect the power cord by grasping the
plug, not the cord.
CLEANING AND MAINTENANCE
• WARNING! Ensure that the appliance is
switched off and disconnected from the
power supply and turn off the water tap
before
performing
operation; never use steam cleaning
equipment – risk of electric shock.
• Use caution when draining hot water from
the
drum
such
maintenance.
any
maintenance
as
during
pump
SERVICE
• Do not repair or replace any part of the
appliance or attempt any service unless
specifically stated in the user manual. Use
only authorized After-sales Service. Self or
non-professional
dangerous incident resulting in live or
health
threatening
property damage.
• In the event of fault and/or malfunction, turn
off the appliance, close the water tap and
do
not
tamper
Immediately contact the Customer Service
Centre and only use original spare parts.
Failure to observe these instructions may
jeopardise appliance safety.
• Certain internal parts are intentionally not
grounded and may present a risk of electric
shock during servicing. Service personnel
– Do not contact the following parts while
the appliance is energized: inlet valve(s),
drain pump, heat sink of the motor
controller, PCBs.
• Always unplug the appliance from the
power supply before attempting any
service. Disconnect the power cord by
grasping the plug, not the cord.
• Before the appliance is removed from
service or discarded, remove the door to
prevent children from playing or hiding
inside. Also remove the power cord/plug.
91
repair
may
lead
and/or
significant
with
the
machine.
to
Publicidad
