Exo Terra PT2060 Manual De Instrucciones página 5

Installation
Main parts
1. 6 ft (1.80 m) power cord
2. Ceramic socket
3. Wire guard
4. Hanger
5. Clamp
1
5
3
Clamp Installation (hanger portion not required):
Note: This clamp must not be used to mount this lamp onto any
glass item, terrarium, shelf, or aquarium. Attach Wire Light ONLY
on the frame of the terrarium, not on the glass.
1. Screw light bulb into the Exo Terra
wattage guidelines). TIP: apply a thin layer of petroleum jelly to
the threads on the base of the light bulb before screwing it in.
This will make it easier to unscrew the bulb when it is time to
replace it.
2. Attach the clamp bracket to the lamp socket, wide part of the
bracket goes around the socket (adjust the screw to widen the
bracket as necessary).
3. Insert the narrow, rounded end of the clamp between narrow part
of the bracket and tighten the screw until the clamp is
firmly secured.
4. Attach the lamp to the top rim portion of your terrarium (not to
the glass part of the terrarium). Note: squeeze the clamp to open
it, release the clamp to close it. Test that the Wire Light is firmly
secured to the terrarium by gently tapping the lamp with your
fingers. Ensure that the lamp is positioned over the top metal
screen portion of your terrarium and NOT over any glass, plastic
parts, or other flammable material. Failure to do so could result in
a possible fire hazard.
5. Keep unit out of reach of children. Keep unit away from curtains
or other flammable objects.
Installation hanging from the ceiling or an elevated platform
(clamp not required):
A
2
2
3
Wire Light (follow maximum
®
4
1