Exo Terra PT2060 Manual De Instrucciones página 6

1. Screw light bulb into the Exo Terra
wattage guidelines). TIP: apply a thin layer of petroleum jelly to
the threads on the base of the light bulb before screwing it in.
This will make it easier to unscrew the bulb when it is time to
replace it.
2. Insert Hanger into the mounting brackets located on either side
of the lamp socket (A).
3. Suspend Exo Terra
platform using a chain or other recommended suspension
method. Ensure that the lamp is positioned over the top metal
screen portion of your terrarium and NOT over any glass, plastic
parts, or other flammable material. Failure to do so could result in
a possible fire hazard.
4. Keep unit out of reach of children. Keep unit away from curtains
or other flammable objects.
Installation with Light Bracket (Sold separately PT2223):
1. Screw light bulb into the Exo Terra
wattage guidelines). TIP: apply a thin layer of petroleum jelly to
the threads on the base of the light bulb before screwing it in.
This will make it easier to unscrew the bulb when it is time to
replace it.
2. Insert Hanger into the mounting brackets located on either side
of the lamp socket (A).
3. Clean the outside surface of the terrarium glass.
4. With the protective backing still intact, place the Light Bracket
support on the back or the side of the terrarium to determine its
final position.
5. Mark the position with a wax pencil or other marker.
6
6. Remove the protective backing and carefully fit the Light Bracket
support within the marked area.
7. Make sure the tape is pressed evenly against the terrarium glass
and that no air bubbles are showing.
8. Press the adhesive sides firmly against the glass panel for at
least 30 seconds.
9. Wait a few moments and make sure the tape is attached firmly to
the terrarium before suspending the fixture.
10. Once in place, the Light Bracket should not be removed.
11. Adjust the height and tighten the screw of the Light Bracket
when the Exo Terra
at the desired height.
12. Remove the first rubber washer and slide the ring of the fixture's
support tightly in between both rubber stoppers.
13. Adjust the position of the Exo Terra
remaining rubber washer.
14. Replace the first rubber stopper to secure the ring of the fixture's
support tightly in between both rubber stoppers.
15. Ensure that the light's focal point is not positioned above any
plastic parts of the terrarium or screen cover to prevent damage.
16. Keep unit out of reach of children. Keep unit away from curtains
or other flammable objects.
GUARANTEE
This unit is guaranteed for defects in material or workmanship for
a period of 1 year from date of purchase. The guarantee is valid
with proof of purchase only. The guarantee is limited to repair or
replacement of the unit only and does not cover consequential loss
or damage of or to animate or inanimate objects. This guarantee
Wire Light (follow maximum
®
Wire Light from ceiling or other elevated
®
Wire Light (follow maximum
®
Wire Light is suspended above the terrarium
®
Wire Light by moving the
®