Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Do not use product unless the battery cover is fully closed
and latched. NEVER allow water to enter the battery
compartment.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
STARTING/STOPPING THE PUMP
See Figure 8.
„ Press the ON/OFF button on the control panel to turn on
the product.
„ Press the ON/OFF button again to turn off the product.
NOTE: The control panel contains the ON/OFF button,
low battery LED indicator, water sensor LED indicator,
timer button, and timer LED indicator.
WARNING:
Unit should always be turned off, with the battery pack
removed, when not in use. Do not leave pump on while
unattended. Failure to follow these instructions could
result in serious personal injury.
NOTE: If the pump is first connected to a battery with the
switch in the ON position, the pump may not start. To start
the pump, turn the pump OFF and then ON.
USING THE TIMER FEATURE
See Figure 8.
„ Depress the ON/OFF button to start the pump.
„ Press the timer button.
„ Each press of the timer button sets the timer to 5 minutes
and the succeeding press adds another 5 minutes.
NOTE: The timer can go up to 15 minutes only.The se-
lected running time is indicated by the corresponding LED.
NOTE: If the topmost timer LED indicator is on, the timer is
set to 5 minutes. If the middle LED indicator is on, the timer
is set to 10 minutes. If the bottom LED indicator is on, the
timer is set to 15 minutes.
„ After the preset time has elapsed, the pump will turn off
automatically.
„ To switch the timer function OFF, press the timer button
until the timer indicator lights go out.
USING THE PUMP
See Figures 9 - 12.
WARNING:
Do not use the submersible pump without the filter
installed.
OPERATION
NOTE: The filter switch that toggles the filter function is
found below the submersible pump.
For use in shallow areas
„ Attach the removable base by aligning the tabs on the
base with the slots on the submersible pump.
„ Press pump into the base until the locking tabs engage.
„ To remove, press one of the locking tabs while gently pull-
ing up on the pump. When the base disengages, press
the second locking tab and remove the pump.
For all other uses
„ Place controller on a dry, flat, stable surface, at a minimum
distance of 3 feet from the edge of the body of water.
„ Tie a rope to the carrying handle of the submersible pump
and lower the submersible pump into water using the
rope. Do not lift or lower the submersible pump using
the hose or power cord.
WARNING:
The submersible pump can only be submerged to a
maximum depth of 14 ft. Do not exceed the maximum
immersion depth for the pump.
„ Ensure pump is securely seated at the base of the body
of water.
„ This pump is capable of discharging water up to 23 ft.
above the level of the water.
NOTE: Do not run the pump dry, as it could shorten the life
of the pump.
„ Attach the discharge hose.
„ Install the battery pack.
„ Submerge the submersible pump into the area to be
evacuated.
„ Secure the battery box onto a stable support using the
hook, if desired.
„ If not using the wall hook, set the battery box on a dry,
level surface. Do not leave pump unsupervised while in use.
WARNING:
Place controller on a dry, stable surface, at a minimum
distance of 3 feet from the edge of the body of water.
Ensure depth of water and location of pump does not
exceed remaining length of cord. Do not place pump on
an underwater ledge where it may fall and pull the control-
ler into the water. Place pump at the bottom of the body
of water. Do not leave product unsupervised during use.
7 – English
Publicidad
