Beper 70.241 Manual De Instrucciones página 8

USB Tower Fan Use instructions
CONTROL PANNEL (fig. 2)
1.Power on/off button
2.Wind speed button
3.Led light button
4.Power button
5.Low speed button
6.Medium speed button
7.High speed button
8.Led light
USE
1.Plug the USB line (included) into the fan and into a USB port or remove the batteries cover at the
bottom of the fan by pushing the tab inward, insert 4 fresh AA batteries (not included) into the batte­
ries compartment according to the polarity directions. Replace the battery cover.
2.Press the POWER button to turn the unit on.
3.Press again to shut the unit off.
4.Press SPEED button to change the fan's air floe speed setting:
a.I low
b.II medium
c.III high
5.An led light will show the current speed.
6.Press the led button to turn the led light on.
7.Press again to shut the led light off.
CLEANING
Before cleaning switch off the fan.
Cleaning the fan with a soft cloth, eventually lightly wet with water. Do not use alcohol or chemicals
substances as thinners or other detergent.
Do not spray water or liquids on the fan, to prevent from damages.
Dry every parts before using again the fan.
If not used during the winter period, keep the appliance in a dry and clean place.
TECHNICAL DATA
Use USB cable (included) or 4 AA batteries (non included)
DC: 5V
Potenza: 2.5 W
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
8