Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
„ Light wood assembly
„ F inish and trim work
„ D ecorative moldings
„ P icture frame assemblies
„ J oint and dowel pinning
„ W indow beading crafts
ATTACH BELT CLIP
See Figure 1, page 11.
The belt clip can be installed on the left or right side of the
nailer, depending on operator preference.
„ Align hole in belt hook with hole in tool's base.
„ Install screw to secure belt hook in place.
„ To uninstall, remove screw and then belt hook.
TO INSTALL/REMOVE BATTERY PACK
See Figure 2, page 11.
To install battery pack:
„ Align raised ribs inside tool with grooves on battery pack.
„ Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in tool before
beginning operation.
NOTE: Pull the secondary trigger to reactivate nailer.
To remove battery pack:
„ Locate latches on battery pack and depress to release
battery pack from the tool.
„ For complete charging instructions, see the operator's
manuals for your battery pack and charger.
NO-MAR PAD
See Figure 3, page 11.
The no-mar pad attached to the nose of the tool helps
prevent marring and denting when working with softer
woods.
Remove the battery pack. Remove the pad by pulling it up
and away from the nose. To replace the pad, fit it into place
over the nose and push down to reseat.
On-board storage for the pad is located on the magazine of
the tool. An extra no-mar pad is provided in the on-board
storage area.
LOADING THE TOOL WITH PIN NAILS
See Figures 4 - 5, page 11.
WARNING:
Keep the tool pointed away from yourself and oth-
ers when loading nails. Failure to do so could
result in possible serious personal injury.
„ Remove battery pack from the tool.
„ With the nose of the tool pointed away from you, squeeze
magazine release button located at the rear of the
magazine and slide the magazine cover open.
„ Place pin nails in the channel with nail tips pointing down
and away from the tool resting on bottom of the channel.
„ Push the magazine cover closed until it securely snaps
into place.
„ Make sure that the magazine is securely locked in place.
„ Reinstall battery pack, and reactivate nailer by pulling the
secondary trigger.
DEPTH OF DRIVE ADJUSTMENT
See Figure 6, page 12.
The depth adjustment knob increases or decreases the depth
with which a nail is driven into the workpiece.
NOTE: Harder materials will require the knob to be adjusted
to a deeper position.
„ Remove battery pack from the tool, if installed.
„ Turn the depth of drive adjustment left or right to change
the driving depth.
„ Reinstall battery and reactivate the tool by pressing the
worklight grip switch.
„ Drive a test nail after each adjustment until the desired
depth is set.
NOTE: Set depth of drive at the shallowest depth that
will meet your needs.
8 — English
Publicidad
