Zibro Kamin R 316 C Instrucciones De Uso página 52

1 1 2 2 a a
1 1 3 3 a a
1 1 4 4 b b
1 1 4 4 a a
1 1 5 5
1 1 7 7 a a
1 1 8 8 a a 1 1 8 8 b b
1 1 8 8 c c
1 1 8 8 d d
1 1 9 9 a a
1 1 9 9 b b
12 Install the wick to the wick sleeve according to the allo-
1 1 2 2 b b
wed direction engraved on the wick sleeve.
13 Install the wick sleeve (with wick) to the primary air
tube. And then install the top of the stem into the
groove of the wick sleeve (with wick) from right side,
and left the stem left to the end.
1 1 3 3 b b
14 Install the wick life extender (the wick position should
be adjusted at No. 1), spring and bracket. Then tighten
the screw which is holding the stem.
15 Put the wick holder chassis back into position.
16 Screw the four wing nuts hand tight.
17 Place the knurled wick adjustment knob on the wick
mechanism. Turn the knob as far to the right as
possible. Press the tip-over switch. Check that the wick
1 1 6 6
can be lowered completely. Repeat this check a number
of times. If the wick cannot be lowered completely it
has not been placed correctly. If this is the case, repeat
the procedure from No. 6.
18 Put the cabinet back into position and tighten the three
screws. Put the knurled wick adjustment knob back into
1 1 7 7 b b
position. Now put the combustion chamber back into
position. Check that it is level by sliding it slightly to the
left and the right by its handle. Close the grill.
19 Put the filled removable tank into position. Put the
batteries into the battery holder (ensure that the
positive and negative poles match the + and – marks
indicated on the battery housing). Wait 30 minutes
after replacing the tank and batteries before using the
heater.
4
49