Keenray EL10 Manual De Instrucciones página 4

USING FOR FIRST TIME
1. Remove all packaging materials, plastic bags and labels.
2. Please make sure that the electricity supply follows the specifications.
3. Clean the Food Tray / Chute & Strainer Assembly / Squeezing Auger / Juicing
Bowl/ Pusher with Soapy water. Then rinse and dry thoroughly.
NOTE : DO NOT IMMERSE THE POWER BASE UNIT IN WATER.
4. Assemble the parts per the instruction in the assembling method section.
5. Connect the power cord to the power source.
The unit is ready to use now.
ASSEMBLING METHOD
Please make sure the unit is not plugged and the switch is turned to "O" setting prior
to assembling the machine.
1. Position the squeezing bowl on the Power base aligning the position of the spouts
and the axle. (Fig 1)
2. Push the squeezing auger firmly into the center of the bowl, making sure that it
touches down the bottom, or else the cover cannot be closed. (Fig 2)
3. Position the chute on the bowl to align the ▲ to the "
it clicks the safety lock. Please make sure that the arrow ▲ on "
with the Lock graphic on the Bowl. (Fig 3)
4. Place the juice container and the pulp container under the relevant spouts. (Fig 4)
" and twist it clockwise until
" the cover aligns
05
OPERATION INSTRUCTION
1. Connect the unit with Power.
2. Check and make sure all parts are well assembled in correct position.
3. Make sure the machine is at off "O" position.
4. Make sure the juice and pulp containers are in position.
5. Make sure the juice spout cover is closed.
6. Prepare the fruits or vegetables and cut them into pieces max 2cm x 5cm strips
or 2cm x 2cm cubes.
7. Put fruit strips/cubes into the chute.
8. Press the switch to setting " -" to start the juicing operation.
9. Push the food down with the pusher only.
10. In case of food stuck inside the Bowl, please switch to "R" reverse function
instantly.
NOTE : Please do not use the juicer continuously longer than 20 minutes.
Open & Close of Juice Spout Cover
During the juicing process, you could keep the Drip-Stop Cover closed before the
juice is full in the juicing bowl. (Fig 5)
BENEFITS OF DRIP-STOP COVER :
1. To stop dripping at the end of juicing.
2. To mix the juice with different fruits and veggies.
USAGE TIPS :
1. Remove hard pits or seeds prior to pressing to prevent possible damage to
the squeezing screw.
06