Keenray EL10 Manual De Instrucciones página 5

2. If mixed juices are to be made, please begin with harder fruit, and then
squeeze the soft fruit.
3. Please let the juicer to run for 30 seconds after the last ingredient was fed.
ATTENTION :
The juicer is not suitable for juicing very hard or fibrous and starchy fruits or
vegetables such as Sugar Cane. There are some fruits which contain too much
starch to juice.
Some examples are Avocado, Bananas, figs, Mango, Papaya, Dragon Fruit,
Strawberry, Grape without seeds etc. They will clog up the stainless steel sieve.
DISASSEMBLING METHOD
NOTE :
If the juicer gets overheated, it will turn off automatically to protect the machine.
In this case, please turn the juicer off "O" . Wait 10 minutes to let the juicer cool
down and then turn it on again.
To disassemble the unit after using and before cleaning. Please turn the juicer
to "O" position and disconnect the juicer from power source.
Then, please follow the steps below :
1. Remove the Juice and Pulp containers. (Fig 6)
2. Remove the Chute. Turn the chute anti-clockwise until the ▲ aligns with
the" " sign. (Fig7)
3. Remove the Squeezing Auger by pulling it out upward. If it is very hard,
swing gently and pull. (Fig 8)
4. Remove the Squeezing Bowl by lifting it upward vertically. (Fig 9)
07
CLEANING & MAINTENANCE
IMPORTANT :
Please wash the juicing parts every time immediately after each used, otherwise
the pulp might stick tightly in Juicing Bowl & Squeezing Auger which will then affect
the disassembly, cleaning and juicing performance.
1. Switch off and unplug the juicer.
2.Wash the disassembled parts (Fig 10) with water. If the meshes are clogged with
pulp, please use the provided cleaning brush to remove the dregs.
Attention:
• Do not use iron wire brush, abrasive or sharp object tool to clean the unit.
• Please do not use water above 40°C.
• Never clean any parts in dishwasher to avoid damage by hot water.
3. In case there is any residues remained in the mouth of the pulp spout, please pull
out the silicone valve as shown in (Fig 11) below and clean under running water.
Press the silicone valve to close it property and tightly after cleaning.
4. To clean the seal ring in the center of the squeezing bowl, please follow the steps
as below :
a. Turn the Squeezing Bowl upside down for easier handling, Push the seal ring out
with your thumb (Fig 12a) and clean it with water.
b. After cleaning, please put it back to the center hole. The small ribbed surface
should be face upward (Fig 12b) Make sure the groove of the seal ring well fit in
the Squeezing Bowl.
c. The big flat size of the seal ring will be inside while the small and ribbed side is
outside the Squeezing Bowl. (Fig 12c)
08