Anker Solix Serie Manual De Instalación página 21

WARNING
• After completing all the installation steps, please check the connection of the plug from the inverter to the Schuko cable and
make sure the plug is assembled correctly.
• Please note that there is only one correct position for the plug. The center of the plug has two slots, a larger slot A and a smaller
slot B, as well as a protrusion C. The correct way to insert it is to align the larger slot A with the protrusion C. Below is a photo of
the plug.
A
• Incorrect operation can result in the inability to align and tighten the plug. Please try again to ensure that the larger slot A
corresponds to the protrusion C.
• When you align the plug and insert it carefully and rotate it, you will find that the two plugs fit perfectly.
• If a short circuit is caused by incorrect operation, please disconnect the power immediately and contact our customer service
staff for product replacement. We apologize for any inconvenience caused.
Balcony Solar Power System Installation Steps Overview
• Step A: Find a suitable location to install the balcony solar power system.
• Step B: Install the first solar panel.
• Step C: Install the microinverter.
• Step D: Install the second solar panel.
• Step E: Connect the solar panel to the microinverter via the solar panel's extension cable, then wait for 90 seconds.
NOTE: This step must be done with sufficient sunlight for the solar panel to provide power to the microinverter.
• Step F: Scan the QR code and download the Anker app. Follow the in-app instructions to complete the microinverter
configuration and Schuko cable connection.
NOTE: This step must be done while your home's electrical grid has power.
• Step G: After 20 minutes, you will get the balcony solar power system's data on your Anker app.
NOTE: According to the government's regulations and to ensure safety, the microinverter can only start working after connecting
to a powered grid for 5 minutes. To improve the accuracy of the data, the system will verify and validate it for 15 minutes before
showing it on the app.
Components Overview
Solar Panel Tilt Mount Brackets
1
2
3
5
4
35 EN
B C
7
6
1. 304 Stainless Steel Hose Clamp (K)
2. U-Shaped Rack (D)
3. Vertical Support Scaffolding (B)
4. Lower Support Beam (C)
Solar Panel
Microinverter
1
4
5
3
Note: The product's appearance varies by supplier and batch.
1. Mounting 3. Wi-Fi Module
2. AC Connector 4. QC4 Female Socket
5. Fastening Clamp (E)
6. Solar Panel Support Beam (A)
7. Silicone Buffer Pad (L)
2
5. QC4 Male Pin
EN 36