Anker Solix Serie Manual De Instalación página 27

1. Place the silicone buffer pads onto the U-shaped racks, then mount the U-shaped racks to the vertical support scaffoldings.
D x2
B x2
1006
Vertical Support Sca olding U-Shaped Rack
mm
2. Mount the solar panel support beams on the solar panel.
A x2
1160 Solar Panel Support Beam
mm
3. Install the vertical scaffolding and solar panel support beams without tightening the screws.
B x2
1006` Vertical Support Sca olding
mm
H x2
M6×14 Hexagon Flange Bolt
4. Mount the lower support beams and adjust the angle for maximum sunlight exposure.
Note: Make sure that both ends of the lower support beams are aligned with the same number.
47 EN
L x2 H x4
Silicone Bu er Pad M6×14 Hexagon Flange Bolt
H x4 J x4
M6×14 Hexagon Flange Bolt M6 Flange Nut
C x2 H x4
600
Lower Support Beam M6×14 Hexagon Flange Bolt
mm
5. Tighten all the screws with 5N.m torque.
N x1
Hexagon Wrench
6. Connect the solar panel with the solar panel extension cable.
Note: To avoid falling, secure the solar panel extension cable on the balcony railings temporarily with zip ties.
7. Hang the solar panel on the balcony railing and adjust the U-shaped racks manually to fit the shape of the balcony railing.
B
C
45 40 35 30
A
5N.m
EN 48