Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA / Ο∆ΗΓΊΕΣ ΑΣΦΑΛΕΊΑΣ / ИНСТРУКЦИИ ПО ТЕХНИКЕ БЕЗОПАСНОСТИ
Tighten the two downrod setscrew. To ensure the setscrew
fully seat against the downrod, it is necessary to back off
locknut until it contacts the setscrew head prior to tightening
the setscrew. When setscrew is tightened against downrod,
locknut should then be tightened against connector yoke,
repeat for both.
HUGGER STYLE
Fasten the canopy to the top of the fan motor
housing with 3 screws provided. Hanger the canopy
from the tab on the hanger bracket. This will allow
you to make the electrical connections without
having to hold the fan up. Make the wire
connections. Put 2 screws in the hanger bracket,
leaving them partially out. Place the canopy up on
the hanger bracket by inserting the slotted opening
of the canopy on the screws. Insert the remaining
screws through the remaining canopy holes and
tighten all 4 screws
BLADE ATTACHMENT
Attach the fan blades to the blade arm. The 3 small screw should be used to attach each blade to the blade arm
with trim. Remove the 6 screws from the underside of the fan motor and switch housing assembly and use these
to attach the blade arm and blade to the motor housing. Tighten the screws securely.
Cuba ref. 33352
Tighten motor screw. Check the strength of this connection by
holding the motor housing in position and turning the downrod
counter clockwise if this connection slips, retighten motor setscrew
and locknut.
Install ball into the hanger bracket opening. The tab opposite of the
hanger bracket opening should fit in slot on ball.
faro - 14
Publicidad
