Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE: Attach the accessory in the desired
orientation for the task at hand. The shaft is
configured so that the application tool can be
installed around the tool in 30° increments
(Fig.7). Do not attach the plunge-cut blade,
flush circular blade, rigid scraper blade, or
carbide grout-removal blade so that they face
backwards, as attachment in this position may
cause serious injury.,
WARNING
the lock pattern of accessories fit each
other . Misalignment can lead to unstable
attachment, causing personal injury .
WARNING
moval blade so that they face backwards, as operation in this position may cause
serious injury .
CAUTION
the tool body to guard against bruising when locking the clamping lever . Do not place
your hands or fingers between the locking rod and drive shaft.
To Remove the Accessory
a. Make sure that the ON/OFF switch is in the OFF position and remove the battery pack.
b. Turn the clamping lever counterclockwise until you hear a "click" to signal that the lever has
been fully engaged to unlock the clamp mechanism.
c. Rotate the locking rod 90° clockwise, and then pull it off.
d. Remove the accessory from the tool.
NOTICE: Do not allow the locking rod face downward when removing the accessory. It may
cause the accessory to fall off unexpectedly.
16
Make sure that the ribs of
the tool drive shaft and
Do not attach the plunge-
cut blade, flush circular blade, rigid scraper blade or carbide grout-re-
To avoid pinching skin, hold the clamping lever firmly when fastening
an accessory. Do not place hands or fingers between the lever and
Fig. 7
o
-30
o
-60
o
-90
o
0
o
30
60
o
o
90
Publicidad
