Fellowes Metal E-200r Instrucciones página 11

COIL DIAMETER & DOCUMENT SIZES
Metal coil diameter sizes
To select the correct size metal coil for a document use the document measure card, stored in the storage tray.
SET UP
1
Ensure the machine is on a
stable surface.
4
Plug the machine into an easily
accessible mains socket. Switch
the mains supply on.
BEFORE YOU BIND
1
Tabla Orientativa de Medición
Guia de medidas
Document Measure
Select the correct coil diameter to
suit the document.
2
Check the waste tray is
empty and correctly fitted.
5
Switch the machine on using the
power switch located at the rear of
the machine.
2
Test punch scrap sheets to check
edge guide setting.
Tabla Orientativa de Medición
3
Fit the supplied power lead to
the power socket at the rear of
the machine.
3
Adjustable back-stop margin feature.
Set the guide to suit the back margin size required (2,3,4 or 5mm)
Eg: 2mm suits small documents (2-50 sheets), 5mm suits the largest
documents (200-450 sheets)
Guia de medidas
Document Measure
12