Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL ASSEMBLY INSTRUCTIONS
A Phillips head screwdriver is required.
2
1
6c
6b
10
11
15
16
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed
5. Turn the collection tank on its side and insert the four caster feet into the slots on the collection
tank and tighten with supplied screws. Verify that the caster feet are mounted correctly. Do not
6. Position the hose storage rack as illustrated. Fully insert one end of the hose storage rack into
the slot illustrated by the arrow, then pull the other end of the hose storage rack to align with
NOTE: The dust collection bag is for dry pick-up only.
10. Place the powerhead back on the collection tank and secure into place using the latches
3
6d
12
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
4
5
7
8
13
8
6a
9
14
Publicidad
