GE PTW905 Manual Del Propietario E Instalación página 4

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
PROPER INSTALLATION
This washer must be properly installed and located in accordance with the Installation Instructions before it is used.
Ensure that the hot water hose is connected to the "H" valve and the cold water hose is connected to the "C"
valve.
Install or store where it will not be exposed to temperatures below freezing or exposed to the weather, which
could cause permanent damage and invalidate the warranty.
Properly ground washer to conform with all governing codes and ordinances. Follow details in the Installation
Instructions.
Ensure washer is properly leveled and washer legs are adjusted such that unit is stable.
Optional drain hose extension recommended for discharging heights from 60" - 96".
GE Appliances strongly recommends the use of factory specified parts. A list of factory hoses available for
purchase are listed. These hoses are manufactured and tested to meet GE Appliances specifications.
GE Appliances strongly recommends the use of new water supply hoses. Hoses degrade over time and need
to be replaced every 5 years to reduce the risk of hose failures and water damage.
Consider recycling options for your appliance packaging material.
START-UP SEQUENCE
Any time the washer is being started or restarts after the washer lid has been opened and closed, the washer
will turn on the cold water valve or drain pump for two short periods followed by a 10 second pause before
continuing. If the lid is opened during this period, the washer will pause. You will have to push the Start button
again to restart the cycle.
AUTOMATIC DRAIN SEQUENCE
Machine will automatically drain any time the lid is left open for more than 15 minutes and water is present.
Machine will automatically drain if left in a paused state with the lid closed for more than 24 hours and water is
present.
While in WATER STATION mode, machine will automatically drain after changing the cycle knob to another
cycle. On some models, this feature may only be available through the GE Appliances SmartHQ App.
WHEN NOT IN USE
Turn off water faucets to minimize leakage if a break or rupture should occur. Check the condition of the fill
hoses; GE Appliances recommends changing the hoses every 5 years.
PARTS AND ACCESSORIES
Order on-line at GEApplianceparts.com today,
24 hours a day or by phone at 800.626.2002 during
normal business hours. In Canada, visit your local
GE Appliances parts distributor or call 800.661.1616.
READ AND SAVE THESE INSTRUCTIONS
4
Part Number Accessory
PM14X10002 4 ft rubber water supply hoses
Or
PM14X10005 4 ft braided water supply hoses
WH49X301 Drain hose extension
PM7X2 Washer Floor Tray
49-3000295 Rev. 0