Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
TD - MIXVENT SERIES
The TD - MIXVENT mixed flow range of in-line duct exhaust fans have been
manufactured in accordance with the rigorous standards of production as defined by
the International Quality Standards ISO 9001. All the components have been checked
and tested at the end of the manufacturing process.
We recommend that you check the following after receiving this product:
1. The correct size has been received
2. The correct model has been received
3. The details on the rating label correspond to the electrical supply: voltage,
frequency etc.
Remove the unit from packaging and inspect for shipping damage within 15 days
of receipt. If the product is found to be damaged, immediately contact your local
authorized supplier. DO NOT OPERATE THE UNIT IF DAMAGED.
These instructions should be considered as a supplement to EPA standard practices,
as well as all state and local building code regulations.
ENVIRONMENT
The TD-Mixvent series of fans are suitable for operation within indoor environments
only, except the TD-250 and 315x which are UL approved for outdoor use. The TD-
Mixvent units are suitable for the exhaust or supply of both conditioned and un-
conditioned airstreams within the temperature ranges (inclusive of duct airstream's
temperature) of -40°C up to +40°C for models TD-100,-100X, -125 & -150; and -40°C
up to +60°C for models TD-200, -200X,-250 & -315.
INSTALLATION
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, OR INJURY
TO PERSONS, OBSERVE THE FOLLOWING:
(a) Use this unit only in the manner intended by the manufacturer. If you have
any questions contact the manufacturer.
(b) Before servicing or cleaning the unit, switch the power off at the service
panel and lock the service disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting means cannot be
locked; securely fasten a prominent warning device such as a tag to the
service panel.
(c) Installation work and electrical wiring must be done by qualified person(s)
in accordance with all applicable codes & standards including fire rated
construction.
(d) Sufficient air is needed for proper combustion and exhausting of gases
through the flue (chimney) of fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturers guideline and safety standards
such as those published by the National Fire Protection Association (NFPA)
and the American Society For Heating, Refrigeration and Air Conditioning
4
Publicidad
