Silvercrest SSH 600 B2 Instrucciones De Uso página 21

Fault causes and remedies
The following table will help you to identify and rectify minor
malfunctions:
Fault
The appliance
will not switch
on.
The appliance
switches itself to
standby mode.
Note: If the above-mentioned solutions do not resolve the prob-
lem, please contact Customer Service (see section Service).
Appendix
Technical specifications
Input
Output
High heat level
Low heat level
Protection class
│ GB │ IE
■ 18
Possible cause
The plug is not con-
nected.
The mains socket is not
supplying any power.
The tilt cut-out has
been activated.
The set heating time
has expired.
220–240 V ∼ (AC), 50 Hz
II /
Remedy
Insert the plug com-
pletely into the mains
power socket.
Check the house mains
fuse.
Plug the appliance up-
right into the mains sock-
et with the display 3 at
the top.
Increase the heating
time if you wish.
600 W
500 W
(double insulation)
SSH 600 B2