Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Area surface burners will not ignite or area
surface burners do not ignite uniformly.
Surface burner flame is yellow or
Wiring Diagram
CCD-0007992 Rev: 09-06-23
PROBLEM/SYMPTOM
orange instead of blue.
POSSIBLE CAUSE/SOLUTION
Surface control knob has not been fully
rotated to the HI position.
Check to see if gas valve is open.
If not, open it.
Burners are clogged. Make sure burner is
off. Use a small wire, toothbrush or needle to
clean burner ports and slots.
Low gas level in tank. Refill or replace the
gas tank.
There is moisture on the burner. With burner
off, dry burner throughly.
Debris may be present in gas line. Let burner
run for a few minutes to see if flame changes
to blue.
Humid air in the home, sometimes caused
by running a humidifier, may cause flames to
burn yellow.
- 13 -
Publicidad
