Publicidad
Idiomas disponibles
Idiomas disponibles
This appliance conforms to the directive:
ANSI Z21.57-2010 Recreational Vehicle Cooking Gas Appliances, ANSI Z21.57a-2012 Addenda to Recreational Vehicle
Cooking, Gas Appliances CAN1-1.16-M79 (reaffirmed 2016) Propane Cooking Appliance For Recreational Vehicles.
WARNING
ALWAYS PERFORM A GAS LEAK CHECK BEFORE USING GAS RANGE!
WARNING
BEFORE TESTING FOR GAS LEAK
1.
Ensure gas range controls are in their OFF positions.
2.
Never test for leaks with any open flames present.
3.
Do not smoke when testing for gas leaks.
4.
Use a soapy solution to detect gas leaks. If there are bubbles present, there is a gas leak.
Before operating the gas range, always preform an analysis or check for a gas leak. DO NOT use gas range until the leak test is
preformed and confirmed there are no gas leak indications. Test for leaks by using between 11-13.8 in. wc. pressure.
● If there is a gas leak detected, replace the defective part recommended by the manufacturer or tighten the loose joint
properly.
● Leak testing of the appliance shall be conducted according to the manufacturer's instructions. Do not use a flame to check
for gas leaks. Use a brush to spread a soapy water mixture around the area you are checking. If there is a gas leak, you will
see small bubbles in the soapy water mixture at the leak point.
GENERAL RECOMMENDATIONS
1.
Plug in the power cord. Make sure the outlet meets local or national electrical codes .
2.
Slide the range into place.
3.
Check the gas supply line to make sure it did not get
damaged and it stayed connected during positioning.
4.
Check to make sure the back leg of the range has slid
into the anti-tip bracket. Carefully tip the range forward
to ensure that the anti-tip bracket engages the back
brace and prevents tip-over.
WARNING
Electrical Grounding Instructions:
This appliance is equipped with a (three-prong) grounding plug for your protection against shock hazard and
should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from
this plug.
WARNING
Disconnect the electrical supply before servicing the appliance.
LEVELING THE RANGE
The range must be level to obtain proper operating. The four screws type leveling legs located on the corners at the bottom of
range should be adjusted by turning them clockwise to make the range higher or counter-clockwise to lower the range until the
range is level. Use a level on surface units to check the leveling of the range.
Anti-Tip/Front Foot Bracket Installation
To reduce the risk of tipping the range by abnormal usage or improper door loading, the range shall be secured by properly
installing the anti-tip device packed with the appliance.
●
Place the anti-tip bracket on the floor as shown figure. Anti-tip bracket can be installed on either right or left side.
●
Make the locations of 2 holes of anti-tip bracket on the floor.
●
Secure bracket to floor using screws.
●
Slide range into position.
●
Slide the front foot bracket under the front of the range and push until bracket is up against the front foot.
●
Secure bracket to the floor. (Recommend #8-15 x 1" wood screw, not provided).
NOTE: If range is relocated, the anti-tip bracket and front foot bracket must be removed and installed in the new
location.
- 6 -
CCD-0007992 Rev: 09-06-23
Publicidad
