Publicidad
Idiomas disponibles
Idiomas disponibles
EN
If you decrease the speed all the way, the unit will
stop and it is necessary to start the machine again.
11.4 TURBO BUTTON
1.
Push the turbo button (2), the machine is at the
highest speed.
2.
Release the turbo button (2), the machine is at
the normal speed.
Using the turbo button drains the battery the fastest.
Only use the turbo button when needed.
11.5 OPERATION TIPS
• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete
work.
12
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic and make the plastic
unserviceable.
Do not use strong solvents or detergents on the
plastic housing or components.
Remove the battery pack from the machine before
maintenance.
12.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks
of electrical shocks.
NOTE
NOTE
CAUTION
CAUTION
WARNING
WARNING
English
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
• Banned washing
13
TRANSPORTATION AND STORAGE
Remove the battery pack from the machine before
transportation and storage.
13.1 STORE THE MACHINE
• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
14
TROUBLESHOOTING
PROBLEM
The motor
does not start
when you pull
the trigger.
The machine
does not start.
The air does
not flow
through the
tube when you
start the ma-
chine.
10
WARNING
POSSIBLE
SOLUTION
CAUSE
Make sure that
The battery pack
you tighlty in-
is not installed
stall the battery
tightly.
pack in the ma-
chine.
The battery pack
Charge the bat-
is out of power.
tery pack.
The power
switch is defec-
tive.
Replace the de-
fective parts by
The motor is de-
an approved
fective.
service center.
The PCB board
is defective.
The air inlet or
Remove the
tube outlet has a
blockage.
blockage.
Publicidad
