Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
Model no
CB-910C
Voltage
220-240 V~50-60 Hz
Class II
OPERATION
Remove the fan heater from the box and bag carefully.
Make sure that the Power & Mode button is in the off position (0) before plugging the appliance into the outlet.
The heater must be placed on a solid, flat surface.
Connect the power plug to an electrical outlet. Make sure the plug is securely attached to the outlet. If it is not
well fitted, it may overheat and damage the outlet. The cable and plug assembly may become hot during use.
This is a normal situation and it does not interfere with the proper functioning of the device.
Turn the thermostat regulator to the maximum setting.
Turn the Power & Mode button to the desired programmed temperature. The low temperature is represented by "I"
and the high temperature by "II".
For fan operation only, without any heat production, turn the Power & Mode button to the fan setting.
To turn off the appliance, turn the Power & Mode button to the off position (0). Then remove the plug from the
outlet.
This appliance is equipped with overheating protection. If the appliance becomes too hot, the heating element
is automatically switched off. To switch the appliance off, set the on/off switch to "0" and unplug the heating
level switch from the mains socket. Let the appliance cool down for at least 10 minutes. Check the air inlets
and outlets and rectify the cause of overheating before recommissioning the appliance.
This appliance is equipped with tip-over protection, which is located on the base of the appliance. If
the appliance is accidentally knocked over or subjected to significant inclination during operation, it is
automatically switched off. The appliance works exclusively in an upright position.
CLEANING AND MAINTENANCE
Before cleaning, always unplug the heater and allow it to cool down sufficiently.
Do not use flammable or abrasive detergents such as benzene or white spirit to clean the heater.
Clean the exterior with a damp, soft cloth, a vacuum cleaner or brush.
Never immerse the heater in water.
Clean the air inlet and outlet gratings regularly with a vacuum cleaner.
If you do not plan to use the heater for a certain period of time, we recommend that you store it in its original
packaging in a cool, dry place, away from direct sunlight, excessive dirt and dust.
20
Power level(model I)
Power level(model II)
600W
1200W
Publicidad
