cecotec COMINO 1000 Manual De Instrucciones página 31

5. CLEANING AND MAINTENANCE
Cleaning
To clean the blades properly, first rinse the jug with water. Fill the jug with 400 ml of
-
lukewarm water and add some detergent soap. Close the jug with the lid and run the
machine in PULSE mode for 2 seconds at a time. Repeat the process as many times as
necessary.
- To finish cleaning the food processor, turn the power knob to the "0" position, turn the
switch off and unplug the appliance after each use and before cleaning.
Use water to clean the jug. Do not use chemical or harsh abrasive cleaning agents.
-
- Never submerge the motor base or the blade holder in water.
Use a dry, soft cloth to clean the motor base. Do not clean this part with a wet cloth.
-
The following parts are dishwasher safe: food pusher, processing bowl lid, tool holder
-
(processing shaft-A), tool holder (processing shaft-B), cutting blade unit, plastic kneading
blade, disc holder, fine shredding blade, fine shredding blade, french fries blade, squeezing
cone and squeezing filter.
Maintenance
If the product does not operate normally, produces uncommon noises or shakes more than it
normally does, stop using the product and contact the Technical Support Service of Cecotec for
reparation. Do not carry out maintenance tasks yourself.
Storage
After cleaning the device, make sure it is thoroughly dried before storing it.
-
- After using the product, store it in a dry, safe place.
- Avoid direct exposure to sun light.
Make sure it is stored in a place out of the reach of children.
-
6. TROUBLESHOOTING
Problem
The food
processor does
not work
Possible causes
The appliance is
not plugged in.
Possible solution
Connect the mains plug to an earthed wall socket.
ENGLISH
31
COMINO 1000