Parkside Performance PPTSA 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 36

GB MT
Safety information
for the saw­blade
This­information­on­the­saw blade complies
with­standard­DIN­EN­847-1:2017.
The­tool­may­only­be­used­by­trai-
ned,­experienced­people­who­know­
how to handle tools.
Safe working
•­The­maximum­speed­stated­on­the­tool­
must­not­be­exceeded.­If­indicated,­the­
speed range must be complied with.
•­Circular­saw­blades­with­cracks­in­them­
must be taken out of service (repair is not
permitted).
•­Tools­with­visible­cracks­must­not­be­
used.
•­Tools­must­be­cleaned­regularly.
•­Tool­parts­made­of­light­metal­alloys,­
e.g. resin, may only be cleaned with sol-
vents that do not impair the mechanical
properties of these materials.
•­Tools­and­tool­bodies­must­be­tightened­
in such a way that they cannot become
loose during operation. Please note the
information on assembly.
Tighten­the­clamping­screw­holding­the­
saw­blade­in­place­hand-tight­using­the­
enclosed­hex­key.
•­Extending­a­spanner­or­tightening­with­
the help of hammer blows is not permit-
ted.
•­The­tightening­surfaces­on­the­saw­blade­
must be cleaned to remove any dirt,
grease, oil and water.
•­Use­original­spare­parts­from­the­ma-
nufacturer to ensure safe use, see the
section­"Spare­parts/accessories".
•­Maintenance­work­and­modifications­to­
circular saw blades should only be per-
formed by a professional, i.e. a person
36
with­specialist­training­and­experience­
who is familiar with the design require-
ments and the necessary safety steps.
Cleaning
• Remove any dirt, such as resin, from the
saw blade using only solvents that do
not impair the mechanical properties of
the saw blade.
•­Try­to­clean­resinous­surfaces­with­a­
damp, lukewarm cloth that has been
wrung­out­well.­Make­sure­that­no­liquids­
can get into the interior of the housing!
Alternatively, you can use a special clea-
ner (resin solvent) or multispray. Please
take notice of the safety information and
instructions provided by the manufactu-
rer of the special cleaner/multispray.
Maintenance
•­Check­the­saw­blade­for­obvious­defects­
after each use and replace a blunt or
bent blade or one which has been da-
maged in some other way.
•­Maintenance­work­on­the­saw­blades,­
such as repair or regrinding, should be
performed by a professional.
Storage
Store the saw blade in a dry and dustproof
location and out of reach of children.
Operation
Removing/inserting the
battery
1.­ To­remove­the­battery­(34)­from­the­
device, press the release button (35)
on the battery (34) and pull the battery
(34) out.