Parkside Performance PPTSA 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 40

GB MT
Moving­sideways­during­the­cut­
can­cause­the­saw­blade­to­jam,­re-
sulting in kickback. When making plunge
cuts that are not made at right angles, se-
cure the saw table against moving side-
ways.
Sawing (with guide rail)
Right angle sawing
• Place the guide rail (31) on the work-
piece with the black rubber lip facing
downwards.
• Place the device with the groove on the
guide rail.
• Hold the machine with both hands, one
hand on the handle (6) and the second
on­the­auxiliary­handle­(1).
• Switch on the device, see chapter
"Switching­on/off"
• Lower the plunge saw and saw for-
ward with moderate pressure – never
backward.
Mitre cuts up to 45°
• Place the guide rail (31) on the work-
piece with the black rubber lip facing
downwards.
• Place the device with the groove on the
guide rail.
• Set the desired cutting angle as descri-
bed­in­the­chapter­"Setting­the­cutting­
angle".
• Hold the machine with both hands, one
hand on the handle (6) and the second
on­the­auxiliary­handle­(1).
• Switch on the device, see chapter
"Switching­on/off"
• Lower the plunge saw and saw for-
ward with moderate pressure – never
backward.
40
Plunge sawing with guide rail
• Place the guide rail (31) on the work-
piece with the black rubber lip facing
downwards.
• Place the device with the groove on the
guide rail.
• Set the desired cutting depth as descri-
bed­in­the­chapter­"Setting­the­cutting­
depth".
• Place the rear edge of the saw table
(10) (as far as possible) against a stop.
• With the eccentric screws (8)
the­fitting­accuracy­of­the­saw­
table in the guide rail can be
improved.
Tighten­the­eccentric­screws­(8)­to­mini-
mise the play between the device and
the guide rail (31).
• Hold the machine with both hands, one
hand on the handle (6) and the second
on­the­auxiliary­handle­(1).
• Switch on the device, see chapter
"Switching­on/off"
• Lower the plunge saw and saw for-
ward with moderate pressure – never
backward.
Setting the speed and
ECO Mode
Use­the­
(22) button to set one of the 6
speed levels.
An­ECO­Mode­is­also­available.­The­ECO­
LED­indicator­ (19) ­lights­up­when­the­ECO­
Mode­is­active.
Switching on/off
Switching on:
1. Push the switch lock (3) forward.
2. Operate the on/off switch (5).
Once the machine has started
up, you can release the switch lock (3).
3. Lower the plunge saw.