kayami SD 2000 Manual De Instrucciones página 21

2. Press" " button to set timer(00-12hours). Pressing the button one time
increases one hour for timer. After setting time, the display will show current
setting time for 5 seconds, then resume to previous display, meanwhile the light
of " " will on.
Appointment "ON": In standby mode, press
in 00-12 hours. After complete setting, the display shows the appointment turn-on
time and also the light "
each hour passed. When the appointment power-on time arrived, the product will
automatically turns on. The default setting temperature is 23 ℃ during appointment
turn-on.
An example to set appointment turn-on time to 8 hours:
Note: If not setting the temperature and weekly program, the product will automatically turn-off after 12
hours of continuous work, and enter into standby.
Function operation (ONLY by remote control)
Note: Remote control, please use 1pcxCR2025(3V) lithium battery , is matched with the
heater
1. Set current TIME/DAY (can set both under standby mode & working status):
Press " "button for one time, the display shows "12" as default,press"
" to set current hour; press "
" to set current minute ,then press "
/
" " to set current day(Monday-Sunday: d1-d7) . Then press"
/
display will show previous settings.
For example: Setting to Wednesday, 9:30 AM under 25℃ under II heating, pls. refer to the following photos:
timer button, you can set the appointment turn-on time
" is on. The display automatically decreases 1 hour for
" again, the display shows minute " 30", press"
" for third time, the display shows the day"
SD 2000
An example of setting 8h:
/
", press
" to confirm the setting, the
21