kayami SD 2000 Manual De Instrucciones página 22

SD 2000
Note:
- The above setting was continue to memorized after power off . then press" " to check the current
time & day in turn; -The timer is in 24 hours.-00~59 minutes.
2. Press" "button for one time, the product works with low heating(1000W) and display shows"-- / I".
Press again, changes to high heating(2000W) and display shows " -- / I / II".
3.Set temperature
During working status, Press" ",the display shows "23 " as default. Press
/
" ",to set desired temperature (temperature range 10-49℃), press"
/
" to confirm the setting.
For example： The, current ambient temperature is 15℃, when set temperature to 25℃, the
display shows as below:
Note:
When setting temperature, it will use SMART working way:
1) Setting temperature – ambient temperature>2℃, working with high power-2000W;
2)0℃<Setting temperature – ambient temperature=<2℃, working with low power-1000W;
3) Setting temperature – ambient temperature=0℃, the cool fan will work for 30seconds to below out the
heating left inside, and then enter into standby mode.
4) after enter into standby mode, if the machine cool down and:
Setting temperature – ambient temperature>=2℃, the machine will wake up and resume to heating.
If you want to cancel the setting temperature, press " " key to choose the heating I or II, the product
will work without setting temperature. While the display " ℃ " will go off, and will show "--". After continuous
heating for 12hours, the cool fan will work for 30seconds and enter into standby mode.
22