kayami SD 2000 Manual De Instrucciones página 23

Set weekly program(ONLY by remote control)
After complete setting of current TIME/DAY, below is the steps to set weekly program:
1)Press " ", the product enter into working status.
2)Press " ",the display shows "P", it enter into weekly program setting.
3).Press" ",the display shows d1~d7, set to working day(Monday-Sunday: d1~d7). Such as set
Monday:
Note: For both current day & set working day:Monday-Sunday: d1~d7
4).Press" ", the display shows P1~P6 (for each day, it can be set maximum 6 time periods).Such as
setting P1:
5).Press" ",the display shows 00"as default. Press"
Such as set the turn-on time 7:00am;
6).Press" ",the display shows the previous step turn-on time by default. Press
to set the turn-off time. Such as set the shutdown time at 13:00pm:
7).Press" "to setting the target temperature(Temperature range 10-49℃);
/
8). Repeat steps 3-7 above, you can set the whole weekly program. Then press"
9). To cancel the weekly function, press the "
is off. The product will revert to the previous function working status.
Note:
-After the above setting are completed and P program is working, press"
the setting time of each day and time periods,
",set working temperature under different time periods.
-Press" /
- The turn-on time periods 00~24hours, cannot set to minutes;
-The"TIME/OFF "cannot be less than "TIME/ON";
-When the "TIME/ON" is the same as "TIME/OFF", the time period enter into standby mode;
" continuously to set the turn-on time.
" again , the light "P" will go off. The weekly program
/
SD 2000
continuously
"to confirmed;
"to check
/ /
23