Ametek Sorensen XPF Serie Manual De Instrucciones página 31

*RST
*SRE <nrf>
*SRE?
*STB?
*WAI
Miscellaneous Commands
*IDN?
ADDRESS?
*TST?
*TRG
Error Messages
Each error message has a number; only this number is reported via the remote control interfaces.
Error message numbers are not displayed but are placed in the Execution Error Register where
they can be read via the remote interfaces, see Status Reporting section.
30
Resets the instrument to the remote control default settings with the exception of
all remote interface settings and Output state at power-on setting. (see Remote
Operation Defaults paragraph in the Remote Interface Operation section)
Set the Service Request Enable Register to <nrf>.
Returns the value of the Service Request Enable Register in <nr1> numeric
format. The syntax of the response is<nr1><rmt>
Returns the value of the Status Byte Register in <nr1> numeric format. The
syntax of the response is<nr1><rmt>
Wait for Operation Complete true. As all commands are completely executed
before the next is started this command takes no additional action.
Returns the instrument identification. The exact response is determined by the
instrument configuration and is of the form <NAME>,<model>,<Serial No.>,
<version><rmt> where <NAME> is the manufacturer's name, <model> defines
the type of instrument, Serial No. is the unique serial number and <version> is
the revision level of the software installed. The format of <version> is
X.xx – Y.yy where X.xx is the revision of the main instrument firmware and Y.yy is
the revision of the Interface board firmware. The Interface firmware is field
updateable by the user via the USB port.
Returns the bus address of the instrument; This is the address used by GPIB, if
fitted, or may be used as a general identifier over the other interfaces.
The PSU has no self test capability and the response is always 0 <rmt>
The PSU has no trigger capability. The command is accepted but performs no
action.