Metronic Billy Manual Del Usuario página 12

EN
POWER SUPPLY
• Connect the mains adapter to the input located at the back of the radio, under
the waterproof cover, then plug into a mains socket. Always use the correct AC
adapter. Otherwise, your radio may malfunction or be damaged.
• For cordless operation, you can use batteries. Using a suitable screwdriver,
unscrew the battery compartment door on the back of the radio and remove it.
• Install 6 LR14 type batteries observing the correct polarity. Then replace the
flap and reinsert the screw to keep the compartment watertight. If the radio
does not turn on, check installation and polarity, or change the batteries.
• Always remove the batteries if you won't be using the radio for a long time.
• The device can run on batteries for on-the-go use. The autonomy is then about
72 hours for listening to the radio at an average volume or about ten days in
display of the time display only. For economic and environmental reasons, it is
strongly recommended to use rechargeable batteries and not disposable
alkaline batteries.
Note: When batteries are low, the radio will emit a low battery warning if NOT connected to mains power. Please
replace or recharge your batteries ASAP.
FM RADIO
• Turn on the radio by pressing the
• Select FM radio mode: Press MODE to enter FM RADIO mode: the FM indicator
and frequency will appear on the screen.
• Press the SCAN button for 2 sec to automatically search for radio stations with
strong reception. All available stations will be stored in order of their registration
number and the first pre-stored radio station will be broadcast automatically.
• In FM radio mode, press button
your choice.
Note: You can try moving the FM antenna for better reception.
BLUETOOTH PAIRING
• Turn on the radio by pressing the
• Press the MODE button to enter Bluetooth mode. The display will show BLUE.
• Press the MODE button to enter Bluetooth mode. The display will show BLUE.
In your device settings, go to the Bluetooth function, search for SP57 in the list of
your devices and select it. After pairing, your radio will emit a tone to confirm
successful pairing.
• Play music from your phone or favourite streaming service.
SETTING THE TIME
• To set the time, put the product on standby (press the Off button for 2 sec) then
long-press the clock button to enter time-setting mode.
• Press the fast forward or fast reverse buttons to increase or decrease the hour digit.
• Press the clock button again to set the minutes.
12
, a beep sounds.
or to select the pre-stored radio station of
, a beep sounds.
Hotline: hotline@metronic.com