GE UVI7361 Manual Del Propietario Y Instalación página 19

INSTALLATION - VENTED TO THE OUTSIDE
STEP 10: INSTALL DUCT COVER
SUPPORTS
horizontal and ceiling supports using 4 screws
per duct cover support.
Ceiling
support
Horizontal
support
49-7000198 Rev. 0
Installation Instructions
Screws
Duct cover
support
STEP 11: INSTALL DUCT COVERS
IMPORTANT: Two people are required to install the
duct covers.
NOTE: If you are installing this hood for
recirculating operation, place the duct covers onto
the hood with the venting slots at the top. If the
hood is vented to the outside, the holes should be
positioned on the bottom.
support assembly. The tabs on the edges of the
duct cover will slide into a notch on the duct cover
support. When all 6 tabs on the duct cover are in
the notches on both of the duct cover supports,
slide the duct cover up so it sits on the duct cover
support spring clip.
Left duct cover
Duct cover
support spring clip
cover clip onto the
bottom of the rear
lower duct cover
locking the clip into
place. Repeat on
the other side.
cover into the
recess on the hood, being careful to hold the clip
in place while lowering the duct cover onto the
hood assembly.
the hood locking it onto the duct cover clip on the
rear cover.
where the front and rear duct covers meet. This
will hold the rear and front covers together.
(Cont.)
Duct cover clip
19