Publicidad
Idiomas disponibles
Idiomas disponibles
Timer
• With the timer control button, you can program when you automatically want to turn on
or turn off the air circulator fan.
– ON Timer: If you press the timer button, with the device turned off, you can set
when you want the air circulator fan to turn on, in a range of 0.5h to 15 hours.
– OFF Timer: As long as the air circulator fan is working, user can program how
long he wants the air circulator fan to continue working. After this time the air
circulator fan will automatically stop working. Time range between 0.5h and 15
hours.
REMOTE CONTROL (Fig. 2)
• Make sure that the battery of the remote control is correctly located. When replacing the
battery, make sure it is the same type (CR2032 3V).
• With the remote control, you can control the air circulator fan as well as Control keypad
located on the base of it.
• Always point the remote control to the receiver (Fig. 1.6), located on the base of the air
circulator fan.
• The remote control can work up to 3 meters from the receiver, as long as no obstacle
between them that complicate the communication.
• The remote control must not be exposed to hits, humidity and long sunlight exposure.
• Do not use abuse the use of remote control if it is not required.
• In order to avoid losing the remote control, it can be deposited on the base of the device
where a magnet will keep it fi xed.
MAINTENANCE
• Before carrying out any maintenance work, make sure that the device has been discon-
nected from the mains.
• This device does not require any special maintenance. To clean the exterior of the fan
with a slightly wet cloth is enough. Leave grids free of fl uffs and dust.
• If you want to do an internal cleaning, you can access inside, removing the screw that
fi xes the frontal grille (Fig.1.1)
DO NOT USE NEITHER ABRASIVE PRODUCTS NOR SOLVENTS.
REMOVAL FROM SERVICE, DISPOSAL AND RECYCLING
EU regulations and our commitment to future generations oblige us to recycle used
materials; please remember to dispose of all unwanted packaging materials at the
appropriate recycling points, and to drop off obsolete equipment at the nearest waste
management point.
10
Publicidad
