Publicidad
Idiomas disponibles
Idiomas disponibles
4. When charging, it is normal that the charger and
battery pack may become warm to touch.
5. If the battery pack does not charge properly:
a. Check current at power outlet by plugging in
another appliance.
b. Plug and unplug to check whether the charger is
ok
c. Check if the battery or the charger are damaged
d. Move the charger and battery pack to a location
where the surrounding air temperature is
approximately 65
e. If the charging problem persists, take the tool,
battery pack and charger to an authorized service
center.
f. Under certain conditions, when the charger is
plugged into the power supply, the exposed
charging contacts inside the charger can be
shorted by foreign material. Foreign materials of
a conductive nature such as metallic particles
should be kept away from charger cavities.
Always unplug the charger from the power supply
when there is no battery pack in the charger or
before attempting to clean
CAUTION: Do not operate or store the charger
in rain or wet condition to avoid electrodes
corrosion and shortening the life. Charge battery
packs after the electrodes are completely dry in
case they are wet. Replace the electrodes if obvious
verdigris appears.
EN
PROBLEM SOLUTION
1.I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
a) Check if the charger and the battery pack are
specifically designed for working together.
b) The battery can be inserted into the charger only
in one direction. Turn the battery around until it
can be inserted into the slot, the indicator light
should be green and flash when the battery is
charging.
2. REASONS FOR DIFFERENT CHARGING
TIMES
The charging time can be affected by many reasons
which are not defects in your product.
a) If the battery pack is only partly discharged it may
be re-charged in less than rated charging time.
b) If the battery pack and ambient temperature are
very cold/ hot, it may take longer to re-charge.
Please find an appropriate environment with
proper air temperature to start charging.
c) Batteries of higher Amp Hour rating require more
charging time.
MAINTENANCE
1. Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
6
0
0
0
0
F to 77
F (18
C-25
C).
Your battery or charger requires no additional
maintenance.
If there is dust in the drain(a), rinse it with clean
water. Wipe clean with a dry cloth. Always locate
your battery, charger and power tool in a dry
place. (See Fig. A)
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
A
2. If there is dust on the windshield, please use a
tool to lift one side of the windshield, remove the
windshield, and rinse with clean water. (See Fig. B)
B
FCC PART 15
SUPPLIER'S DECLARATION
OF CONFORMITY
Product Description : Battery Charger
Model Number : KAC840
Trade Name : Kress
This device complies with part 15 of the FCC
Rules.
Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
a
Publicidad
