Publicidad
Idiomas disponibles
Idiomas disponibles
BM 3609929305 10/01
10/2/01
SLIDE ON-OFF SWITCH WITH LOCK
The tool is switched "ON" by the switch
button located at the side of the motor
housing. The switch can be locked in the
"ON" position, a convenience for long
grinding operations.
TO TURN THE TOOL "ON" without locking
it, slide the switch button forward by
applying pressure ONLY at the REAR portion
of the button. When pressure is released the
switch button will snap to "OFF" position.
TO LOCK THE SWITCH "ON", slide the
switch button forward and press "IN" the
FRONT portion.
TO UNLOCK THE SWITCH, simply press
and release the REAR portion of the button.
Switch is spring loaded and will snap back
automatically.
Hold the tool with both
WARNING
!
hands while starting the tool,
since torque from the motor can cause the
tool to twist.
Start the tool before applying to work and let
the tool come to full speed before contacting
Material
Woods:
Softwoods
Hardwoods
Veneers
Metals:
Steel
Stainless
Aluminum
Rust spots
Synthetic paint:
Sanding
Scratches
Stripping
Acrylic paint:
Sanding
Scratches
Stripping
Plastics
PC/polystyrene
Thermoplastics
Glass fiber reinforsed plastics
2:26 PM
Page 8
Operating Instructions
the workpiece. Lift the tool from the work
before releasing the switch. DO NOT turn the
switch "ON" and "OFF" while the tool is
under load; this will greatly decrease the
switch life.
ELECTRONIC FEEDBACK CIRCUITRY (EFC)
The internal electronic feedback system
provides a "soft start", which will reduce the
stresses that occur from a high torque start.
The system also helps to keep the no load
speed virtually constant between no-load
and load conditions.
VARIABLE SPEED WITH DIAL SETTING
Your sander is also equipped with a variable
speed dial. The sander's orbital pad speed
can
be preset from zero to maximum
nameplate OPM by rotating the dial in the
housing. The dial may be set on or between
any of six positions (1=low through 6=high).
The following table may be used as a general
guide for abrasive and backing pad selection,
but the best results will be obtained by
sanding a test sample of the workpiece first.
Rough
Fine
sanding
sanding
position
Grit size
Grit size
60
240
60
180/240
240
400
80/180
600
120
240
80
240/400
24
120
180
400
120
220
24/40
80/120
180
400/1200
120
224
60
80/120
120
240
60
180
80/120
20/320
-8-
Drive
Switch
Backing
setting
pad
b
1-4
soft
a/b
3 / 6
med
b
1-2
soft
a
3-6
med/hard
a
4-6
med
a/b
1-3
med
a
4-6
soft
b
3
med
a/b
3-4
hard
a
5-6
med
b
3-4
med
a/b
2-4
hard
a
3-6
med
a/b
1-3
soft/med
a/b
1-2
med
a
1-3
med/hard
Publicidad
