Publicidad
Idiomas disponibles
Idiomas disponibles
Care and cleaning
PART
Inside, Outside and Door
Extractor fans
Control panel
Before you call the technical service
To avoid electrocution that could cause severe personal injury or death, never remove the cover or outer housing. The cover or outer
housing must be removed by an authorised technical service.
PROBLEM
The oven does not operate.
If the oven does not allow input
when the buttons are pressed
If the oven
is damaged or displays the
following message:
If the following appears on the
oven screen
The oven operates but
food is not heated.
Low power
(only models with a dial)
RECOMMENDATION FOR CARE AND CLEANING
Clean the microwave by applying a gentle detergent solution and warm water using a
sponge or non-scratchy cloth. Before you clean the appliance, remove excess water from
the sponge or cloth. If you want, boil a cup of water in the microwave to loosen dirt
before you clean it off.
Important:
• Do not use abrasive detergents or cleaning agents that contain ammonium or citric acids.
These could damage the finish.
• Never pour water underneath the microwave oven.
• Do not use pressurised water cleaning systems.
Every month check whether particles have built up along the filter grate at the rear of
the oven. Clean the grate using a damp cloth to ensure a clean flow of air.
Dry it completely
Open the oven door to disable the oven timer. Clean it by applying a gentle detergent
solution and warm water using a sponge or non-scratchy cloth.
WARNING
POSSIBLE CAUSE
Make sure the oven is connected to the power supply
Ensure that the oven is connected to an earthed, polarised circuit.
(Contact an electrician to be completely sure)
Check the fuse or short circuit.
Check that the door is firmly shut.
Make sure that the oven is switched on.
Open and close the oven door. Press the button again.
The oven control is equipped with a self-diagnosis system. The self-diagnosis system
warns you if an error or problem has occurred.
When the electronic control indicates a problem, follow these steps.
1. Note down the number displayed on the screen.
2. Unplug the oven, wait for 1 minute and replug the oven in.
• Disconnecting the power supply could delete the service code. If the fault
persists, contact an authorised service technician.
You have attempted to program the oven for longer than the permitted time.
1. Press STOP/RESET.
NOTE: The maximum cooking time is 60 minutes, except when cooking at full power
(100%). When full power (100%) is used, the maximum cooking time is 20 minutes.
Place a cup of water in the oven.
Operate the oven for one minute at full power (100%).
If the temperature does not increase, the oven is not working properly. Contact and
authorised service technician.
Check the Power level control setting. The control must be set to HIGH.
11
ENGLISH
Publicidad
