Laica DBP-2220 Instrucciones Y Garantía página 19

Table 3 - For ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING
Guidance and manufacturer's declaration
electromagnetic immunity
The DEVICE is intended for use in the electromagnetic environment specified below. The customer or the user of the DEVICE
should assure that it is used in such an environment.
Immunity IEC 60601 Compliance
Electromagnetic environment – guidance
test test level level
Portable and mobile RF communications equipment should be used no
closer to any part of the DEVICE, including cables, than the recommended
385MHz, 385MHz,
separation distance calculated from the equation applicable to the frequency
27V/m 27V/m
of the transmitter.
450MHz, 450MHz,
Recommended separation distance:
28V/m 28V/m
710MHz, 710MHz,
745MHz, 745MHz,
780MHz 780MHz
9V/m 9V/m
Where P is the maximum output power rating of the transmitter in watts
810MHz, 810MHz,
(W) according to the transmitter manufacturer and d is the recommended
870MHz, 870MHz,
Radiated RF
separation distance in meters (m).
930MHz 930MHz
IEC 61000-
Field strengths from fixed RF transmitters, as determined by an
28V/m 28V/m
4-3
electromagnetic site survey,a should be less than the compliance level in
each frequency range.b
1720MHz, 1720MHz,
Interference may occur in the vicinity of equipment marked with the
1845MHz, 1845MHz,
following symbol:
1970MHz 1970MHz
28V/m 28V/m
2450MHz, 2450MHz,
28V/m 28V/m
5240MHz, 5240MHz,
5500MHz, 5500MHz,
5785MHz 5785MHz
9V/m 9V/m
80 MHz to 800 MHz
800 MHz to 2,7 GHz
36
Table 4 - For ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING
Recommended separation distances between
portable and mobile RF communications equipment and the DEVICE
The DEVICE is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the DEVICE can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and the DEVICE as recommended below,
according to the maximum output power of the communications equipment.
Separation distance according to frequency of transmitter
Rated maximum output
power of transmitter
80 MHz to 800 MHz
W
0,01 0,12
0,1 0,38
1 1,2
10 3,8
100 12
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m)
can be determined using the equation applicable to the frequency of the transmitter, where P is the maximum output power
rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection
from structures, objects and people.
m
800 MHz to 2,7 GHz
0,23
0,73
2,3
7,3
23
37