Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
All maintenance should only be carried out by a qualified service technician.
Cleaning
Before cleaning or performing any maintenance, remove the battery pack from the tool.
For safe and proper operation, always keep the tool and its ventilation slots clean.
Always use only a soft, dry cloth to clean your multi-tool; never use detergent or alcohol.
TROUBLESHOOTING
WARNING
• Set the lock on/off switch (E) to the lock position and detach the battery pack from the multi-tool
before performing troubleshooting procedures.
PROBLEM
The multi-tool does
not work.
Strong vibration or
loud noise during
operation.
Motor overheating.
The LED worklight
blinks rapidly
The LED worklight
blinks slowly.
POSSIBLE CAUSE
Battery pack charge is
depleted.
Accessory is not installed
securely.
Cooling vents are
obstructed.
The tool has stopped
working to protect internal
circuits.
Low battery capacity.
CORRECTIVE ACTION
Charge the battery pack.
Reinstall the accessory according
to "Installing and Removing
Accessories".
Clean and clear the cooling vents.
Do not cover vents with hand during
operation.
Release the trigger switch, wait for
the tool to cool down and then start
the tool again.
Charge the battery.
15
Publicidad
