EN
1.2.i - Prolonged machine standstill
-
Place the machine under cover, shel-
tered from atmospheric agents in a place
where the temperature is between 5°C
and +40°C.
-
Remove the ignition key.
-
Drain the clean water contained in the
tank.
-
Charge the batteries and, once they
are charged, disconnect them from the
charger.
-
Charge the batteries once a month.
1.3. INTENDED MACHINE
USE
The machine has been designed and manu-
factured for washing and drying indoor floor
surfaces.
DANGER:
Any other use releases the manufacturer
from responsibility for damage or injury
to persons and/or things and invalidates
any warranty condition.
1.4 - NON-INTENDED
MACHINE USE
WARNING:
The machine is not intended for outdoor
use.
DANGER:
-
washing floors with water which is hotter
than 50°C;
-
using diesel/petrol or corrosive deter-
gents to wash floors;
-
washing and sucking up corrosive, flam-
mable and/or explosive liquids, even if
diluted.
1.4.a - Zone with risk of explosion
It is strictly forbidden to use the machine in
environments where there is a risk of explo-
sion with the presence of flammable and
explosive gases, vapours, liquids and pow-
ders.
1.5. DEMOLISHING THE
MACHINE
In order to protect the environment, proceed
in compliance with local standards in force.
When the appliance can no longer be used
or repaired, proceed with the separate dis-
posal of its components.
Electrical
be disposed of as urban waste
and it is necessary to dispose
of it separately as introduced by
the special regulation regarding
the disposal of waste originat-
ing from electrical equipment
(Italian Legislative Decree no.
151 of 25/7/05 - 2002/96/EC -
2003/108/EC).
The electrical equipment is marked with a sym-
bol showing a wheeled bin with a cross on it.
The symbol indicates that the equipment was
put on the market after 13 August 2005 and
that it must be disposed of separately.
In consideration of the substances and ma-
terials contained, inadequate or abusive dis-
posal of the equipment or its improper use
may cause damage or injury to persons and
the environment.
Disposal of electrical waste which does not
respect the standards in force leads to the
application of administrative sanctions and
penalties.
1.6. REFERENCE
STANDARDS
This machine has been built in compliance
with the machine directive in force and in ac-
cordance with the standards contained in the
EC Declaration of Conformity supplied with
the machine.
EN-6
equipment
cannot