GreenWorks GD60PS25 Manual Del Operario página 4

EN
1 DESCRIPTION
1.1 PURPOSE
The product fitted with a cutting attachment mounted on a
pole to enable the operator to cut the branches of standing
trees but not intends for cutting woods as normal chainsaw.
This appliance is not intended for use by persons (including
children) with reduced understanding, or lack of experience
and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
1.2 OVERVIEW
Figure 1-20
Lock-out button
1
Trigger
2
Scabbard
3
Pole saw handle
4
Collar
5
Extension pole
6
Pole saw head
7
Chain cover lock nut
8
Oil tank cap
9
10 Bar
1.3 PACKING LIST
Pole saw head
1
Extension pole
2
Pole saw handle
3
Scabbard
4
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
11 Chain
12 Oil indicator
13 Chain lubricant
14 Chain cover
15 Shoulder strap
16 Battery pack
17 Battery release button
18 Sprocket
19 Chain tension pin
hole
Shoulder strap
5
Wrench
6
Oil
7
Manual
8
WARNING
English
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2 ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain lubricant as follows.
Use bar and chain lubricant that is only for chains and chain
oilers.
The machine comes from the factory without bar and chain
lubricant.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt enters
in the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for 15 - 40 minutes.
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
3.3 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 10-14.
1. Remove the battery pack from the machine.
2. Remove the chain cover nuts with the wrench.
4
WARNING
WARNING
IMPORTANT
NOTE
IMPORTANT