Publicidad
Idiomas disponibles
Idiomas disponibles
The product is switched on when the LED (a) is
lit.
The product is switched off when the LED (a) is
out.
3. Press the Operator Presence Switch first, then
press the Throttle Trigger to start the machine.
The Trimmer Head rotates.
4. If the warning indicator (b) lights up or is flashing,
refer to Troubleshooting for solutions.
5. Release the Throttle Trigger. The Trimmer Head
stops rotating after a short delay. If the Trimmer
Head continues to rotate, remove the battery and
contact the service agent.
OPERATION:
Starting the trimmer (See Fig. F1, F2)
F1
EN
F2
1. Hold the trimmer firmly with your right hand on
the control handle – wrap your thumb around the
handle. Hold the trimmer with your left hand on
the auxiliary handle– wrap your thumb around the
handle.
2. Hold and press the On / Off Switch until the
green LED is lit. The green LED shows the power
level.
3. Press the Operator Presence Switch first, then
press the Throttle Trigger to start the machine.
The green LED for start/stop goes off after 5
seconds if not being used as a safety procedure.
When not cutting, the unit will remain on if the
operator presence switch is held down without
operating the machine. If the green LED goes
10
out, the product will need to be restarted.
NOTE: The Operator Presence Switch is designed
to prevent accidental operation. When you press the
Operator Presence Switch it releases the Throttle
Trigger.
Selecting the speed
3 Power Levels can be selected depending on the
application. Use the +/- to control the speed, which
is as indicated by the LEDs. The higher the power
level, the faster the tool runs.
Stopping the trimmer
Release the Throttle Trigger to stop the machine.
WARNING! The cutting head continues to
rotate after the trimmer has been switched
off; wait until it has completely stopped then lay
15m (50ft)
down the tool.
Bump-line feed system (See Fig. G)
The trimmer is equipped with a bump-line system.
Just bump the trimmer head while the machine is
running, new line will feed out.
G
15m (50ft)
Cutting Tips (See Fig. H)
H
1. Swing the trimmer from side to side across the
area to be cut.
2. Use the tip of the cutting line to do trimming; do
not force the trimmer head into uncut grass.
15m (50ft)
15m (50ft)
Publicidad
